We can generally understand that the etching process is an extension of the stamping process, and it can replace the product production problems that the stamping process can not solve. Stamping will involve the problem of mold, and most of the stamping mold is relatively expensive, once the mold is determined, if you want to change it again, you need to open the mold again, it is easy to cause the waste of mold and reduce the efficiency of production.

However, the machine etching process solves the problems that the stamping process can not solve, such as: the mold can be replaced at any time, designed, and the cost is low. The randomness and controllability of change have increased greatly. It provides a wider space for designers. At the same time, it also helps the stamping process to solve the problem of stamping edge. However, the etching process is not a panacea. Often need to be combined with stamping to better play their characteristics.

Etching process How to do stamping?

So how does etching do stamping?

Generally after etching with stamping. That is to say, the etching can be designed according to the stamping die to the corresponding stamping point. For example, the shaped and bent positioning holes can be processed at the same time as the etching. There are also some continuous die stamping problems, which can also make the etching product do the corresponding positioning. This is a good solution to the problem of matching stamping after etching. The two processes complement each other! Complementary and mutual assistance, has been widely used in the market.